Space Force 6: Ready to Roll
The second space gat is complete. Enjoy the photos below and check out the build in progress posts to see what it took to get this beauty...
top of page
Kimber K6S Magnetron Revolver Complete 10
1/4
Search
- Jan 22, 2022
Space Force 6: The Build Part V
In Part IV of the build, just when I thought I was getting close to done with the front sight, I had to restart. I'd hacked too much off...
- Jan 4, 2022
Space Force 6: The Build Part IV
At the end of the Build Part Part III, I thought my work on the MCX handguard, EGW Red Dot Mount and LPA Front Sight was done. I was...
- Dec 31, 2021
Space Force 6: The Build Part III
The MCX handguard is now rough fit and attached to the front of the gun. It's time to connect the the front sight post and the red dot...
- Dec 24, 2021
Space Force 6: The Grips
I'm going to try to get fancy on the grips for this space gun.... I'm starting with Ruger's GP100 Factory Rubber Grips and LS Grips'...
- Dec 17, 2021
Space Force 6: The Red Dot & Mount
The first Uncle Fudd project was based on a Space Cowboy theme, which has been taking over the lever action world over the past few...
- Dec 16, 2021
Space Force 6: The Build Part II
In Part I I started work on the illuminated front sight post. Here I get to hacking. The part of this build that takes the most work is...
- Dec 9, 2021
Space Force 6: The Handguard
It guards your hands. You can also mount stuff to it, cut it up to make it fit on a gun that it was never intended to fit on, paint...
- Dec 6, 2021
Space Force 6: Build Part I
This is where this build is going to get a little fancy. Usually, I'm not into cosmetic only modifications to guns. Even if something is...
- Nov 21, 2021
Space Force 6: Initial Design
Teasing the next futuristic gun project here. I'm calling it "Space Force 6." Final design, more details, parts lists, build story, etc....
Send me a note.
bottom of page