3-Gun Tactical Lever Action: The Build Part VI - (Still) Finishing the Stock
I called Part V "Finishing the Stock," because I thought the stock was finished... However, after looking at it for a couple days, I...
top of page
Kimber K6S Magnetron Revolver Complete 10
1/4
Search
- Apr 22
3-Gun Tactical Lever Action: The Build Part V - Finishing the Stock
Way back in Part I, I cut down the wood stock and removed most of the material from the SPS Mounting Plate. With the foundation of the...
- Apr 7
3-Gun Tactical Lever Action: The Build Part IV - Finishing The Foregrip
In Part II, I made the rough cuts to turn a rectangle piece of carbon fiber into a foregrip. In Part III, I tinkered a piece of titanium...
- Apr 3
3-Gun Tactical Lever Action: The Build Part III - Extended Tube Mag
In Part II, I turned a rectangular piece of carbon fiber into a basic extra light foregrip. Time to fabricate the extended titanium...
- Mar 27
3-Gun Tactical Lever Action: The Build Part II - Roughing In the Foregrip
In Part I, I roughed in the stock - adding some hardware to compensate for the notorious .357 Mag recoil and allow for a couple inches of...
- Mar 23
3-Gun Tactical Lever Action: The Build Part I - Roughing In the Stock
It's been a busy couple of months, but I'm finally getting to build this tactical Lever Gat. I've already made a couple plan tweaks since...
- Mar 6
3-Gun Tactical Lever Action: The Gun
Here, my friends, is the foundation of my Tactical Lever Gat build - A Henry Model X in .357 Mag. I chose this Henry for a couple of...
- Jan 24
3-Gun Tactical Lever Action: Initial Design
My dearest Fuddites, it's time to dive into my next abomination. In this project, I am going to step away from the futuristic revolver...
Send me a note.
bottom of page